Brautomat32
English
English
  • Brautomat
  • Installation
  • Basic setup
    • Setting up a temperature sensor
    • Setting up an induction hob
  • The mash plan
    • Controller
    • Functions
    • Recipe
  • AutoTune PID
    • AutoTune process
    • AutoTune step by step
  • Sensors
    • Calibration
  • MLT
  • HLT
  • Actors
  • Logging
  • Parameter overview
    • Parameter kettle
    • Parameter System
    • Functionen buttons
  • Circuit board
    • Connectors
    • Setting up circuit board V2
  • Display
  • 3D print case
    • InnuCase
    • FreggaCase
  • Hardware
  • KleinerBrauhelfer2
  • MQTTDevice
  • Support Brautomat
  • Troubleshooting
Powered by GitBook
On this page

3D print case

There are currently two different cases available for the Brautomat:

  • the InnuCase

  • the FreggaCase

PreviousDisplayNextInnuCase

Last updated 2 months ago