Brautomat32
English
English
  • Brautomat
  • Installation
  • Basic setup
    • Setting up a temperature sensor
    • Setting up an induction hob
  • The mash plan
    • Controller
    • Functions
    • Recipe
  • AutoTune PID
    • AutoTune process
    • AutoTune step by step
  • Sensors
    • Calibration
  • MLT
  • HLT
  • Actors
  • Logging
  • Parameter overview
    • Parameter kettle
    • Parameter System
    • Functionen buttons
  • Circuit board
    • Connectors
    • Setting up circuit board V2
  • Display
  • 3D print case
    • InnuCase
    • FreggaCase
  • Hardware
  • KleinerBrauhelfer2
  • MQTTDevice
  • Support Brautomat
  • Troubleshooting
Powered by GitBook
On this page

MQTTDevice

PreviousKleinerBrauhelfer2NextSupport Brautomat

Last updated 2 months ago

The Brautomat is a stand-alone controller and cannot communicate with a second Brautomat or CraftBeerPi4. A RaspberryPi, a Docker container or another Python3 environment is not required. The Brautomat focuses on simple, intuitive and inexpensive.

The hardware (ESP, temperature sensors, display, GGM IDS2) and the circuit board are identical in both projects. It is possible to switch between the Brautomat and MQTTDevice firmwares at any time without making any changes. The is used with CraftBeerPi4.

MQTTDevice