InnuCase
InnuCase is available in two sizes. Print files are in Housing/InnuCase.
InnuCase #1 (large)
Dimensions: 26 x 9 cm
Typical options:
display + 2 PWM modules + power switch (InnuCase-1_Display_2PWM_Power.stl)
display + 2 PWM modules, no power switch (InnuCase-1_Display_2PWM.stl)
display + 1 PWM module with/without power switch (InnuCase-1_Display_1PWM*.stl)
Connections (depending on variant):
M12 front connectors for actuators
M12 bottom connectors for actuators and sensors
InnuCase #2 (compact)
Dimensions: 20 x 9 cm
Designed for compact setups (display + one sensor).
If no display is used, close the opening with a blind cover.
Suggested components
GX12 aviation connectors (2-pin actuator, 3-pin DS18B20, 4-pin PT100x)
up to 2 PWM modules in InnuCase #1
Housing cover variants
InnuCase #1 lid (Deckel-1_Display_2PWM.jpg)
InnuCase #2 lid (Deckel-2_Display.jpg)
Threaded inserts and mounting
The housing includes pads for threaded inserts. Typical hole diameter in pads: 4.6 mm. Use a soldering iron to set inserts into the pads.
Board carrier plate
The board is mounted on a carrier plate behind the display using M3 spacers (for example 15 mm).
Carrier variants:
smaller plate for DS18B20 setups
larger plate for PT100x setups (with holes for MAX31865 boards)
Bracket and blind cover
A rear bracket can be used for mounting. Blind covers are available for unused display openings.
